Page 1 of 1

Frequency Selective Surface

Posted: Wed 21 Oct 2020, 06:29
by gopugnair11
I need to design a Frequency Selective Surface. How should I get the tetrahedral shape of metal patch? Should I proceed with AddPolygon? The proposed structure is attached here.
Screenshot 2020-10-21 095847.jpg
Screenshot 2020-10-21 095847.jpg (29.18 KiB) Viewed 1306 times
How should I resonate the FSS at 3.5GHz and 4.9GHz so that it acts as a transmitter at 3.5 and reflector at 4.9?

Re: Frequency Selective Surface

Posted: Wed 21 Oct 2020, 08:20
by thorsten
Yes this looks very much like a polygon...

br
Thorsten

Re: Frequency Selective Surface

Posted: Wed 21 Oct 2020, 11:05
by gopugnair11
thank u

Re: Frequency Selective Surface

Posted: Wed 21 Oct 2020, 11:32
by gopugnair11
Here a square patch is printed on a substrate. At two corners a circular disc is made and two feed lines are provided which is partially sandwiched between ground and patch. Two feed lines are connected with these two disks through the plated-through holes .How the feed should be given? Can I use MSL feeding? Only length and width of feed given.
LBE.jpg
LBE.jpg (22.48 KiB) Viewed 1301 times

Re: Frequency Selective Surface

Posted: Thu 22 Oct 2020, 20:14
by thorsten
Yes you can tries MSL lines, or go simpler (but more manual) and use lumped ports at the end...

br
Thorsten