Page 1 of 1

Typo in AutoSmoothMeshLines.m

Posted: Mon 29 May 2017, 16:02
by frankst
Hi Thorsten,

I believe there is a small typo in AutoSmoothMeshLines.m.

Line 155 reads:
warning('CSXCAD:AutoSmoothMeshLines',['method failed to fulfill the max. ratio: ' num2str(results.max_ratio) ' > ' num2str(ratio)]');

But it should be:
warning('CSXCAD:AutoSmoothMeshLines',['method failed to fulfill the max. ratio: ' num2str(results.max_ratio) ' > ' num2str(ratio)]);
(I removed a single quote almost at the end of the line)

Cheers
Frank

Re: Typo in AutoSmoothMeshLines.m

Posted: Tue 27 Jun 2017, 09:07
by frankst
Hi Thorsten,

I fixed some more single quote typos in AutoSmoothMeshLines.m which prevented warnings from showing correctly (on Win10 with Octave 4.2.0).
My edited version is attached.

Cheers
Frank

Re: Typo in AutoSmoothMeshLines.m

Posted: Tue 27 Jun 2017, 19:26
by thorsten
Thanks,

pushed...