Python interface and port

[nats]

Hello,
I'm writing a python tool to optimize some kind of filter and I wanted to use either coaxial port or circular wave guide port but they are not available in the python interface.
Is there a plan to add them ?
Should I try to copy the Matlab version and translate it in python ?

Thanks a lot,

[thorsten]

Well it always was the plan to make the python interface fully equal to the Matlab/Octave one...
But it was always the plan that users could/would help on this too

So feel free to have a look at how the ports are done in general and I would happily have a look at your attempt

best regards
Thorsten