Negative impedance for an antenna at 1 GHz (and 50 Hz)

How to use openEMS. Discussion on examples, tutorials etc

Moderator: thorsten

Post Reply
Posts: 4
Joined: Wed 08 Apr 2020, 04:45

Negative impedance for an antenna at 1 GHz (and 50 Hz)

Post by jjmaloss » Wed 08 Apr 2020, 04:53

Hello. I am running a simulation where an antenna is made of an external wire and a coaxial wire. These two wires are connected through an active and passive lumped ports. Each port has a resistance of 50 ohms. The antenna is approximately 190 mm long. The frequency that I use is is 1 GHz. The passive port has an *negative* impedance of -50 ohms. This does not make much sense. Moreover, a test performed with a frequency of 50 Hz also shows a negative impedance of -50 ohms. It looks like that I am not using the software properly because in the later case, the antenna should actually behave like a basic electric circuit. I would really appreciate if someone could point to the mistake that we are making. Thank you very much in advance.

I attach the 2 simulations.

Jean-Jacques Malosse
Simulation at 50 Hz
(7.66 KiB) Downloaded 423 times
Simulation at 1 GHz
(7.7 KiB) Downloaded 407 times

Post Reply